Lee's Tackle Adjustable Center Rigger Holder

Our Adjustable Angle holders AL7000CR (1-3/8" ID), MX7000CR (1-1/2" ID) and MX8000CR (1-5/8" ID) are our strongest and most versatile holders. The three point mounting distributes the stress and provides side support. This heavy duty unit allows you to set your outrigger angle for maximum efficiency. The angle is set by positioning the clamp on the main tube during installation. The main tube of this unit is designed to accept the outrigger in either end so the holder can be mounted above or below any flat surface. A fast pin can be substituted for the bolt connecting the clamp to the wing for bridge lay down capability. Approximate area required for mounting is 14-1/2" x 18".

Recommended poles for AL7000CR
AO8712CR - 12 ft Center Rigger (Mk II)
AO8715CR - 15 ft Center Rigger (Mk II)
MX8712CR - 12 ft MX Step- Tube Style
TX8712 - 12 ft Telescoping Center Rigger


Recommended poles for MX7000CR
CX8712CR - 12 ft Carbon Fiber
CX8715CR - 15 ft Carbon Fiber
AO8716CR - 16 ft Center Rigger (Mk II)
AO8718CR - 18 ft Center Rigger (Mk II)
MX8712CR - 12 ft MX Step- Tube Style
MX8716CR - 16 ft MX Step- Tube Style
MX8718CR - 18 ft MX Step- Tube Style
MX8716CX - 16 ft MX Step- Tube Style - Single Spreader
MX8720CX - 20 ft MX Step- Tube Style - Double Spreader

Recommended poles for MX8000CR
MX8719CR - 19 ft MX Step- Tube Style
MX8716CX - 16 ft MX Step- Tube Style - Single Spreader
MX8719CX - 19 ft MX Step- Tube Style - Single Spreader
MX8720CX - 20 ft MX Step- Tube Style - Double Spreader
MX8722CX - 22 ft MX Step- Tube Style - Single Spreader or Double Spreader